Search results

The COST2100 channel model is a reference channel model which provides dynamic multiple-input multiple-output channel responses for radio system simulations. In this paper, channels created by the COST2100 model were compared to channel measurements in order to understand behaviours of the model. Model parameters of the COST2100 model were derived by dynamic double-directional channel measurements

A Vernier Gate-Ring-Oscillator (GRO) Time to Digital Converter (TDC) is proposed and implemented in 90-nm CMOS process technology. It utilizes two GRO chains as the delay lines. The time resolution is determined by the difference between two delays, so not limited by the process. Moreover, the quantization noise can be first-order shaped by the gated behavior in the oscillators, which further impr

The increase in demand for high-data rates on the move in the complex urbanenvironment requires either the allocation of new spectrum such as availablecontiguous spectrum in the mm-wave band or the use of novel configurationssuch as the application of massive multiple-input multiple-output (MIMO)technology. To enable the design of efficient wireless networks, an understandingof the propagation phe

This deliverable presents channel measurement results for the scenariosOpen exhibition and Crowded auditiorium. The measurement procedureand equipment are described. Massive MIMO (MaMi) channel characteristicsand key parameters are extracted and used in an extended COST 2100channel model for MaMi. The initial validation performed shows that themodel is capable of reproducing the statistics in term

Massive multiple input multiple output (MIMO) is a revolutionary communication technique, where large numbers of antennas are employed at the base stations to increase the spectral efficiency, reliability and data rate of the system. Moreover, in multi-user MIMO (MU-MIMO) multiple users can be served by the base stations on the same time-frequency resource. Distributed antenna system (DAS) is a fo

The second generation (2G) cellular networks are the current workhorse for machine-to-machine (M2M) communications. Diversity in 2G devices can be present both in form of multiple receive branches and blind repetitions. In presence of diversity, intersymbol interference (ISI) equalization and co-channel interference (CCI) suppression are usually very complex. In this paper, we consider the improve

The choice of channel propagation model used for the simulation-based study of Vehicular Ad hoc NETworks (VANETs) plays a key role in the accuracy of conclusions drawn about the performance of applications proposed for these networks. Relying on simplistic channel models, as frequently practised in previous works, leads either to pessimistic or optimistic conclusions. In the view of this, in this

Urban intersections constitute an important safety-critical scenario for vehicle-to-vehicle communication. Based on measurements, this paper presents detailed investigations of the radio wave propagation processes in a typical urban intersection. We focus on one time instance of the propagation process and set up hypothesis for locations of the scattering objects. Multipath components (MPCs) are i

We consider the problem of designing demodulators for channels with memory that use reduced-size trellis descriptions for the received signal. We assume an overall iterative receiver, and for the parts of the signal not covered by the trellis description, we use interference cancellation based on the soft information provided by the outer decoder. In order to reach a trellis description, a linear

The McEliece public key cryptosystem is an attractive general construction that has received extensive attention over the years. Recently, a very promising version called QC-MDPC, was proposed. By using binary quasi-cyclic codes, the size of the public key can be decreased significantly. The decryption step involves iterative decoding of moderate density parity check codes (MDPC). In this paper we

Automation programming is typically done using blocks and dataflow connections, in diagram languages that support user-defined block types. Often, these types are intended to be instantiated and connected to other blocks in common patterns, corresponding to anticipated variability. We present the new language mechanisms of wirings and recommendations that allow these intentions to be encoded as fe

We consider a multiple-input multiple-output (MIMO) channel with inter-symbol interference (ISI) where signal detection is highly complex due to the large signal state-space dimensionality. A common strategy is to apply a front-end filter (FEF) to eliminate the ISI dimension (i.e. full ISI equalization). This FEF is then followed by a frequency non-selective MIMO detector. However, another, much l

This work presents a digital calibration technique in continuous-time (CT) delta-sigma (Δ Σ) analog to digital converter. The converter is clocked at 144 MHz with a low oversampling ratio (OSR) of only 8. Dynamic element matching is not efficient to linearize the digital to analog converter (DAC) when the OSR is very low. Therefore, non-idealities in the outermost multi-bit feedback DAC are measur

The trend in cellular chipset design today is to incorporate support for a larger number of frequency bands for each new chipset generation. If the chipset also supports receiver diversity two low noise amplifiers (LNAs) are required for each frequency band. This is however associated with an increase of off-chip components, i.e. matching components for the LNA inputs, as well as complex routing o

Decision making and requirements scoping occupy central roles in helping to develop products that are demanded by the customers and ensuring company strategies are accurately realized in product scope. Many companies experience continuous and frequent scope changes and fluctuations but struggle to measure the phenomena and correlate the measurement to the quality of the requirements process. We pr

This paper presents a link adaptive processor to perform low-complexity channel estimation and QR decomposition (QRD) in Long Term Evolution-Advanced (LTE-A) receivers. The processor utilizes frequency domain correlation of the propagation channel to adaptively avoid unnecessary computations in the received signal processing, achieving significant complexity reduction with negligible performance l

Direct conversion receivers are widely used for full duplex mobile radio communication systems. This paper describes a novel SAW-less single-ended RF amplifier connected to a single-ended mixer with a feedback loop that suppresses the second-order distortion from TX cross modulation of the LO-leakage as well as DC-offset at the mixer output. In Monte Carlo simulations the design achieves +47 dBm m

TO-DCF, a new backoff scheme for 802.11, has the potential to significantly increase throughput in dense wireless LANs while also opportunistically favouring nodes with heavier traffic loads and/or better channel conditions. In this paper we present an analytical model to investigate the behaviour and performance of the TO-DCF protocol with regards to operating parameters such as the number of nod